[nabrU]

Cos ode mnie (wybaczcie, że po angielsku):

• 8mm, 10mm, 11mm, 12mm and a 15mm open end and ratchet spanner (all these will do the chain adjusters, and all the remaining odd nuts and bolts on the CRF).
• Three MotionPro tyre levers (08-0284 12-13mm), (08-0288 27mm), (08-0286 22mm) or their Chinese equivalents from Ali,
• Two MotionPro Rim Shield II plastic covers or equivalent,
• 27mm and 22mm socket and drive (you will not break the rear axle torque with the MotionPro levers so either undertorque your axle or carry these).
• 8mm, 10mm and 12mm long reach socket and small driver.
• HW5 Hex.
• 17mm Axle key (Motion Pro 08-0355 T6 Superlight Hex Axle Tool 17,19,22,24 mm or Ali equivalent),
• Flat and cross head screwdriver
• Inner tubes
• Tube patches, glue and rubber gloves.
• Cable ties.
• Spare brake lever (53170-MEJ-016) – the only thing that can stop you dead on the CRF is a broken front brake lever,
• Duct tape,
• Honda fairing clips
• All in a Kriega tool roll